Engine Oil Cooler, Removing And Installing: Removing

WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2009 Audi S5, and 2008 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Generator Bolts -Arrows-

Courtesy of AUDI OF AMERICA, LLC

-- Remove the generator. Refer to GENERATOR .

-- Remove the bolt -arrows- and the generator bracket.

Fig 2: Identifying Bolts And Air Generator Bracket

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the coolant hoses and :3094 as shown in the illustration.

Fig 3: Clamping Off Coolant Hoses With Hose Clamps Hose Clamps Up To 25 mm Dia. 3094

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Use A Cloth To Catch Any Leaking Coolant.

-- Remove the coolant hoses -1 and 2- from the oil cooler.

-- Place the :SMN372500 under the engine.

-- Remove the bolts -arrows- and remove the engine oil cooler.