Engine Oil Cooler, Removing And Installing: Installing

WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2009 Audi S5, and 2008 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note The Following:

Tightening Specifications. Refer to Figure.

NOTE:

Replace O-rings.

Secure all hose connections with hose clamps of the same type as those equipped by the factory. Refer to the Parts information.

-- Install the generator bracket. Refer to OVERVIEW - RIBBED BELT DRIVE .

-- Install the generator. Refer to GENERATOR .

-- Check the oil level. Refer to OIL LEVEL, CHECKING

-- Check the coolant level. Refer to COOLANT, DRAINING AND FILLING - Filling .