LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 116 (Emission Control Systems (Aux. Emission Control Devices) (H4DOTC)) >> PCV Hose Assembly >> Installation

PCV Hose Assembly: Installation

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the PCV hose assembly to the intake duct and the cylinder block RH.
    NOTE: Use a new clamp for the PCV hose assembly, fit the cut out in the ST with the protrusion on the clamp as shown in the figure, and lock the clamp.

    ST 18353AA000 CLAMP PLIERS

    Fig 1: Pinching Clamp Of PCV Hose Assembly Using Clamp Pliers
    G07679888Courtesy of SUBARU OF AMERICA, INC.
    Fig 2: Locating PCV Hose Assembly Clamp
    G07679889Courtesy of SUBARU OF AMERICA, INC.
  2. Install the intake duct. < refer to INSTALLATION , Intake Duct. >
  3. Install the turbocharger. < refer to INSTALLATION , Turbocharger. >
  4. Install the intake manifold. < refer to INSTALLATION , Intake Manifold. >
  5. Install the PCV hose assembly B to the rocker cover LH, and connect the connector (A) to the PCV hose assembly B.
    Fig 3: Identifying PCV Hose Assembly B Connector
    G00522215Courtesy of SUBARU OF AMERICA, INC.
  6. Install the PCV hose assembly A to the rocker cover RH, and connect the connector (A) to the PCV hose assembly A.
    Fig 4: Identifying PCV Hose Assembly A Clamp
    G00522214Courtesy of SUBARU OF AMERICA, INC.
  7. Install the collector cover.
scientia non olet · About LEMON Manuals