Camshaft Position Sensor, Removing And Installing: Installing

WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2009 Audi S5, and 2008 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Replace the O-ring if damaged

-- Coat the O-ring with engine oil and carefully press the camshaft position sensor in by hand.

-- Tighten the camshaft position sensor and connect the electrical connector.

Camshaft position sensor tightening specification. Refer to OVERVIEW - IGNITION SYSTEM .

-- Install in reverse order of removal.