Parking/Auxiliary Heater And Fuel System Clean Working Conditions
WARNING: This page is about a different car, the 2015 Audi RS 5, 2014 Audi RS 5, and 2013 Audi RS 5. However, it is still accessible from the selected car via links, so may be relevant.
Even a little contamination can lead to faults. When working on the fuel supply and on the fuel injection system, Observe The Following Guidelines For A Clean Working Environment:
- Before loosening, connections and surrounding areas must be cleaned thoroughly with engine or brake cleaner, and then cleaned area must be dried completely.
- Seal off any open lines and connections immediately with clean plugs, for example, taken from Engine Bung Set:VAS6122 .
- Place removed parts on a clean surface and cover. Use a lint-free cloth.
- Carefully cover or seal opened components if repairs are not performed immediately.
- Only install clean components: Remove the replacement parts from their packaging just prior to installing them. Do not use parts that have been stored outside of their original packaging (for example in tool boxes etc.).
- When the system is open: Do not work with compressed air. Do not move vehicle unless absolutely necessary.
- Protect the disconnected connectors from dirt and moisture and only connect when they are dry.