Wiper Linkage Assembly: Removal

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Removal steps in this procedure may contain installation details.

NOTE: The hood is removed in this procedure for clarity.

Remove the cowl panel grill. Refer to: Cowl Panel Grille .
1. Disconnect the windshield wiper motor electrical connector.
2. If equipped, detach the windshield electrical connector retainer.
Courtesy of FORD MOTOR COMPANY
Remove the wiper linkage assembly bolts.

Courtesy of FORD MOTOR COMPANY
Remove the wiper linkage and motor assembly.

Courtesy of FORD MOTOR COMPANY
NOTE: Be careful not to damage the link seals during removal. Failure to follow this instruction may result in poor windshield wiper performance.

Detach the RH windshield wiper link from the windshield wiper motor crank.
1. Detach the link.
2. Position the link aside.
Courtesy of FORD MOTOR COMPANY
NOTE: Be careful not to damage the link seals during removal. Failure to follow this instruction may result in poor windshield wiper performance.

Detach the LH windshield wiper link from the windshield wiper motor crank.
1. Detach the link.
2. Position the link aside.
Courtesy of FORD MOTOR COMPANY
1. Position the wiper motor cover to access the linkage bolts.
2. Remove the windshield wiper motor bolts, the motor clamp plates and the wiper linkage.
  Torque: 89 lb.in (10 Nm)

Courtesy of FORD MOTOR COMPANY