LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 1135 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Keyless Entry Rear Antenna >> Removal

Keyless Entry Rear Antenna: Removal

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Short wheelbase shown, long wheelbase similar.
  1. Position the liftgate weatherstrip aside.
    GFD274890Courtesy of FORD MOTOR COMPANY
  2. Release the clips and remove the liftgate scuff plate trim panel.
    GFD274891Courtesy of FORD MOTOR COMPANY
  3. Remove the load floor cover.
    GFD274892Courtesy of FORD MOTOR COMPANY
  4. Position the load floor storage compartment cover up.
    GFD274893Courtesy of FORD MOTOR COMPANY
  5. Remove the vehicle jack assembly.
    GFD274894Courtesy of FORD MOTOR COMPANY
  6. Disconnect the keyless entry rear antenna electrical connector.
    GFD274895Courtesy of FORD MOTOR COMPANY
  7. Remove the load floor storage compartment bolts.
    GFD274896Courtesy of FORD MOTOR COMPANY
  8. Release the clips and remove the load floor storage compartment.
    GFD274897Courtesy of FORD MOTOR COMPANY
  9. Remove the nuts and the keyless entry rear antenna.
GFD275463Courtesy of FORD MOTOR COMPANY