Front Door Glass Run and Bracket: Removal
WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
LH side shown, RH side similar.
- Remove the front door latch. Refer to: Front Door Latch .
- Remove the exterior front door handle reinforcement.
- Detach the cable from the exterior front door handle reinforcement.
- Remove the cable eyelet from the lever.
- Remove the cable from the routing clip.
- Press the locking tab down.
- If equipped, disconnect the door lock cylinder rod. Remove the exterior front door handle reinforcement.
- Remove the front door glass run and bracket.
- Release the retaining tabs on the front door glass run and bracket.
- Remove the front door glass run and bracket.