Second Row Single Seat Cushion Cover: Removal

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Removal steps in this procedure may contain installation details.

NOTE: LH side shown, RH similar.

Remove the second row seat. Refer to: Second Row Seat .
Release the retainers and remove the recline handle cover. Use the General Equipment: Interior Trim Remover

Courtesy of FORD MOTOR COMPANY
Remove screw and the recline handle.

Courtesy of FORD MOTOR COMPANY
Remove the second row seat side shield.
1. Remove the screws.
2. Release the retainers.
Courtesy of FORD MOTOR COMPANY
Remove the second row seat cushion pivot arm cover.
1. Remove the screw.
2. Release the retainers.
Courtesy of FORD MOTOR COMPANY
If equipped. Disconnect the heated seat electrical connector.
- Release the retainers.
Courtesy of FORD MOTOR COMPANY
Release the second row single seat cushion cover J-clips.

Courtesy of FORD MOTOR COMPANY
Remove the second row single seat cushion cover and foam as an assembly.

Courtesy of FORD MOTOR COMPANY
NOTE: Use care when separating the cushion cover from the hook-and-arrows, or the hooks can be torn from the cushion foam.

NOTE: Use care when separating the cushion trim cover from the hook-and-loop strips or the hook-and -loop strips may be torn from the cushion foam.

NOTE: This step is only necessary when installing a new component.

Remove the second row single seat cushion cover.
1. Invert the second row single seat cushion cover.
2. Release the hook and loop strips.
3. Release the hook and arrows.

Courtesy of FORD MOTOR COMPANY