Front Seat Cushion Adjuster - Vehicles With: Multi-Contour Seats: Removal

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Driver seat shown, passenger seat similar.

Remove the front seat cushion cover. Refer to: Front Seat Cushion Cover .
1. Disconnect the front seat cushion blower motor electrical connector.
2. Detach the front seat cushion blower motor wiring harness retainer from the seat cushion suspension.
3. Rotate the front seat cushion blower motor 45 degrees clockwise to unlock it from the seat cushion suspension.
Courtesy of FORD MOTOR COMPANY
Remove the front seat cushion blower motor.

Courtesy of FORD MOTOR COMPANY
Detach the front seat cushion blower motor duct.

Courtesy of FORD MOTOR COMPANY
1. NOTE: After disconnecting the hose and lock assembly, verify the black O-ring and white spacer remains with each hose.
  
  NOTE: When connecting the hose and lock assemblies, an audible click must be heard for correct installation.
  
  Release the locking tab and disconnect the front seat cushion adjuster hose assembly from the SCMG.
2. Detach the pin-type retainer and position the front seat cushion adjuster hose assembly aside.
Courtesy of FORD MOTOR COMPANY
Detach the pin-type retainers and remove the front seat cushion adjuster.

Courtesy of FORD MOTOR COMPANY
NOTE: This step is only necessary when installing a new component.

Remove the front seat cushion blower motor duct.

Courtesy of FORD MOTOR COMPANY