LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 1130 (Seating System - Front (2 Of 2)) >> Removal And Installation >> Front Head Restraint Guide Sleeve >> Removal

Front Head Restraint Guide Sleeve: Removal

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Driver seat shown, passenger seat similar.
  1. Remove the front seat. Refer to: Front Seat .

    Seats with power head restraint 

  2. Remove the front head restraint. Refer to: Front Head Restraint .
  3. Detach the power head restraint electrical connector.

    1. Release the LH head restraint guide sleeve locking tab.
    2. Slide the LH head restraint guide sleeve up.
    3. On both sides. Release the locking tabs.
    4. Slide the power head restraint electrical connector down.

    GFD275088Courtesy of FORD MOTOR COMPANY
  4. NOTE: Do not reuse the head restraint guide sleeves.

    Remove and discard the power head restraint guide sleeves.

    1. Remove and discard the LH power head restraint guide sleeve.
    2. Release the RH locking tab.
    3. Remove and discard the RH head restraint guide sleeve.

    GFD275089Courtesy of FORD MOTOR COMPANY

    Seats with manual head restraint 

  5. Release the back panel straps from the seat track.
    GFD275078Courtesy of FORD MOTOR COMPANY
  6. If equipped with video display.Remove the video display. Refer to: Video Display .
  7. NOTE: The back panel finish can be easily marred or torn, use care when working around it.

    On both sides, grasp the back panel where it meets the module trim, pull to release the clips and separate the back panel from the module trim.

    GFD275090Courtesy of FORD MOTOR COMPANY
  8. On both sides, using the interior trim remover, place it in between the plastic substrate and the clip, pry and detach the module clips from the back panel windows.Use the General Equipment: Interior Trim Remover
    GFD275091Courtesy of FORD MOTOR COMPANY
  9. Pull out at the bottom, release the clips and detach the back panel from the backrest frame.
    GFD275092Courtesy of FORD MOTOR COMPANY
  10. Pull out at the sides of the back panel.
    GFD275093Courtesy of FORD MOTOR COMPANY
  11. Pull down and out and remove the back panel.
    GFD275094Courtesy of FORD MOTOR COMPANY
  12. Depress the locking tabs and remove the manual head restraint.
    GFD271187Courtesy of FORD MOTOR COMPANY
  13. NOTE: Do not reuse the head restraint guide sleeves.

    Remove and discard the manual head restraint guide sleeves.

    1. Release the locking tabs.
    2. Remove and discard the manual head restraint guide sleeves.

GFD275095Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals