Section 113 (Exhaust System (H4DOTC)): Muffler: Installation

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal.

NOTE:

Use a new gasket and self-locking nut.
After assembling, degrease the lubricant which was applied to the cushion rubber while removing/installing.

Tightening torque:

48 N.m (4.9 kgf-m, 35.4 ft-lb)

Fig 1: Locating Muffler Nut At Rear Exhaust Pipe

Courtesy of SUBARU OF AMERICA, INC.