Rear Door Check Arm: Removal

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Removal steps in this procedure may contain installation details.

NOTE: LH side shown, RH side similar.

NOTE: Short wheelbase shown, long wheelbase similar.

Open the rear door.

Courtesy of FORD MOTOR COMPANY
Remove the check arm bolt.
Torque: 17 lb.ft (23 Nm)

Courtesy of FORD MOTOR COMPANY
Remove the rear door trim panel. Refer to: Rear Door Trim Panel .
NOTE: Door removed from vehicle for clarity.

Disconnect the electrical connector, remove the screws and the rear door speaker.

Torque: 13 lb.in (1.5 Nm)

Courtesy of FORD MOTOR COMPANY
NOTE: Door removed from vehicle for clarity.

Remove the rear door check arm nuts.

Torque: 71 lb.in (8 Nm)

Courtesy of FORD MOTOR COMPANY
NOTE: Door removed from vehicle for clarity.

Remove the rear door check arm assembly.

Courtesy of FORD MOTOR COMPANY