Fuel Filler Door Assembly: Removal

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Removal steps in this procedure may contain installation details.

NOTE: The fuel filler door assembly is damaged during the removal process and requires a new fuel filler door assembly installed.

Remove the fuel tank filler pipe. Refer to: Fuel Tank Filler Pipe .
Remove the fuel filler door. Refer to: Fuel Filler Door .
Slice in the indicated areas. Use the General Equipment: Knife

Courtesy of FORD MOTOR COMPANY
Insert the screwdriver and release the clips while pulling the fuel filler door housing away from the vehicle. Use the General Equipment: Flat Headed Screw Driver

Courtesy of FORD MOTOR COMPANY
NOTE: Clearance is limited. When all five clips release, the fuel filler door housing can be rotated.

Rotate the fuel filler door housing.

Courtesy of FORD MOTOR COMPANY
If equipped.Disconnect the electrical connector.

Courtesy of FORD MOTOR COMPANY
Remove the drain tube.

Courtesy of FORD MOTOR COMPANY
Pull the fuel filler door assembly away from the vehicle and remove.

Courtesy of FORD MOTOR COMPANY