DTC Chart: BCM
WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.
Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .
| DTC | Description | Action |
|---|---|---|
| B109F:01 | Intrusion Sensor Module: General Electrical Failure | GO to Pinpoint Test B |
| B109F:02 | Intrusion Sensor Module: General Signal Failure | GO to Pinpoint Test B |
| B109F:08 | Intrusion Sensor Module: Bus Signal / Message Failure | GO to Pinpoint Test B |
| B109F:49 | Intrusion Sensor Module: Internal Electronic Failure | INSTALL a new intrusion sensor. REFER to: Intrusion Sensor . |
| B109F:55 | Intrusion Sensor Module: Not Configured | Using a diagnostic scan tool, PERFORM the LIN New Module Initialization procedure (Toolbox>Electrical>Service Functions>LIN New Module Initialization). |
| B109F:97 | Intrusion Sensor Module: Component or System Operation Obstructed or Blocked | GO to Pinpoint Test B |
| B109F:9A | Intrusion Sensor Module: Component or System Operating Conditions | GO to Pinpoint Test B |
| B11D9:09 | Vehicle Battery: Component Failure | GO to Pinpoint Test B |
| B1305:01 | Hood Switch: General Electrical Failure | GO to Pinpoint Test D |
| All other Diagnostic Trouble Codes (DTCs) | - | REFER to: MULTIFUNCTION ELECTRONIC MODULES . |