Stoplamp Switch: Removal

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Do not press or pull on the brake pedal when installing or removing the stoplamp switch ortherwise misadjustment or damage to the stoplamp switch can occur.

Remove the push pins and remove the LH insulation panel.
- Disconnect the electrical connector.
Courtesy of FORD MOTOR COMPANY
1. Disconnect the electrical connector.
2. Rotate the switch 1/4 turn clockwise and remove the stoplamp switch.

Courtesy of FORD MOTOR COMPANY