LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 1110 (Exterior Lighting (2 Of 2)) >> Diagnosis And Testing >> Turn Signal and Hazard Lamps >> Pinpoint Tests >> Pinpoint Test F : The Turn Signal Indicator Flashes Fast When No Turn Signal Lamps Are Inoperative Or Does Not Flash Fast When A Turn Signal Lamp Is Inoperative >> Notes

Pinpoint Test F : The Turn Signal Indicator Flashes Fast When No Turn Signal Lamps Are Inoperative Or Does Not Flash Fast When A Turn Signal Lamp Is Inoperative: Notes

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.

Refer to Wiring Diagram Turn Signal/Stop/Hazard Lamps for schematic and connector information.

Normal Operation and Fault Conditions 

REFER to: Exterior Lighting - Overview .

REFER to: Exterior Lighting - System Operation and Component Description .

DTC Fault Trigger Conditions 

DTC Description Fault Trigger Conditions
B1265:01 Left Rear Turn Lamp Feedback: General Electrical Failure A continuous memory DTC that sets when the BCM detects an electrical failure from the LH rear turn lamp outage circuit when the turn lamp is activated.
B1266:01 Right Rear Turn Lamp Feedback: General Electrical Failure A continuous memory DTC that sets when the BCM detects an electrical failure from the RH rear turn lamp outage circuit when the turn lamp is activated.
B1497:01 Left Front Turn Lamp Feedback: General Electrical Failure A continuous memory DTC that sets when the BCM detects an electrical failure from the LH front turn lamp outage circuit when the turn lamp is activated.
B1498:01 Right Front Turn Lamp Feedback: General Electrical Failure A continuous memory DTC that sets when the BCM detects an electrical failure from the RH front turn lamp outage circuit when the turn lamp is activated.

Possible Sources