Pinpoint Test D : B13F3:08, B13F3:31 And B13F3:1F: Notes
WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.
B13F4:08, B13F4:31 and B13F4:1F
Refer to Wiring Diagram Parking Aid for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Parking Aid - System Operation and Component Description .
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| B13F4:08 | Right Rear Side Sensor: Bus Signal / Message Failure | A continuous and on-demand DTC that sets in the PAM when there is a message failure on the LIN for the right rear active park assist sensor. |
| B13F4:31 | Right Rear Side Sensor: No Signal | A continuous and on-demand DTC that sets in the PAM when no signal is received on the LIN for the right rear active park assist sensor. |
| B13F4:1F | Right Rear Side Sensor: Sensor Circuit Intermittent | A continuous and on-demand DTC that sets in the PAM when an intermittent fault is detected on the LIN for the right rear active park assist sensor. |
Possible Causes
- Wiring, terminals or connectors
- Right rear active park assist sensor
- PAM
NOTE:
Before disconnecting any of the active park assist sensors, verify the connectors are properly seated and latched.