LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 110 (Manual Transmission And Differential) >> Transmission Mounting System >> Removal >> CROSSMEMBER And Cushion Rubber

CROSSMEMBER And Cushion Rubber

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ground cable from battery.
  2. Lift up the vehicle.
  3. Remove the front and center exhaust pipes. < Ref. to REMOVAL , Front Exhaust Pipe. > < Ref. to REMOVAL , Center Exhaust Pipe. >
  4. Remove the rear exhaust pipe and muffler. < Ref. to REMOVAL , Rear Exhaust Pipe. > < Ref. to REMOVAL , Muffler. >
  5. Remove the heat shield cover.
    Fig 1: Heat Shield Cover
    G07665948Courtesy of SUBARU OF AMERICA, INC.
  6. Set the transmission jack under transmission.
    CAUTION: Always support the transmission case with a transmission jack.
  7. Remove the front crossmember and the rear crossmember.
    Fig 2: Locating Front Crossmember And Rear Crossmember Bolts
    G07665949Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the transmission cushion rubber.
scientia non olet · About LEMON Manuals