LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 110 (Manual Transmission And Differential) >> Main Shaft Assembly for Single-Range >> Installation

Main Shaft Assembly for Single-Range: Installation

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the needle bearing and oil seal to the front of the transmission single-range main shaft assembly.
    NOTE:
    • Wrap the clutch splined section with vinyl tape to prevent damage to the oil seal.
    • Apply NICHIMOLY N-130 (or equivalent) to the sealing lip of the oil seal.
    • Use a new oil seal.
  2. Install the transmission case knock pin into the knock pin hole of the needle bearing outer race.
    NOTE: Align the end face of the seal with surface (A) when installing the oil seal.
    Fig 1: Aligning End Face Of Seal
    G07666027Courtesy of SUBARU OF AMERICA, INC.
  3. Install the drive pinion shaft assembly. < Ref. to INSTALLATION , Drive Pinion Shaft Assembly. >
  4. Install the transmission case. < Ref. to INSTALLATION , Transmission Case. >
  5. Install the transfer case together with the extension case assembly. < Ref. to INSTALLATION , Transfer Case and Extension Case Assembly. >
  6. Install the manual transmission assembly to the vehicle. < Ref. to INSTALLATION , Manual Transmission Assembly. >
scientia non olet · About LEMON Manuals