Main Shaft Assembly for Single-Range: Adjustment
WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
Selection of main shaft rear plate:
Using the ST, measure the protrusion amount (A) of ball bearing from transmission main case surface, and select a suitable plate in the following table.
NOTE:
Before measuring, tap the end of main shaft with a plastic hammer lightly in order to make the clearance zero between the main case surface and moving flange of bearing.
ST 498147001 DEPTH GAUGE
PARTS DIMENSION SPECIFICATION CHART
| Dimension (A) mm (in) | Part No. | Mark |
|---|---|---|
| 4.00 - 4.13 (0.1575 - 0.1626) | 32294AA041 | 1 |
| 3.87 - 4.00 (0.1524 - 0.1575) | 32294AA051 | 2 |