Symptom Chart: HUD
WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.
Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. Refer to: Diagnostic Methods .
| Condition | Possible Sources | Actions |
|---|---|---|
| The HUD is inoperative | Refer to the Pinpoint Test | GO to Pinpoint Test A |
| The HUD setup menu does not display in the IPC or cannot be navigated | Message center concern HUD module |
VERIFY the message center functions correctly using the RH steering wheel switches. If the message center does not function correctly using the RH steering wheel switches, DIAGNOSE the message center menu does not display or cannot be navigated. Refer to: Instrumentation, Message Center and Warning Chimes . If the message center does function correctly using the RH steering wheel switches, GO to Pinpoint Test A |
| The HUD illumination does not increase or decrease | Refer to the Pinpoint Test | GO to Pinpoint Test B |
| The HUD does not display clearly, is distorted or cut off on the windshield | HUD not calibrated | PERFORM the HUD calibration. Refer to: Head Up Display (HUD) Module Calibration . |
| The BLIS/ CTA indication does not display | Refer to the Pinpoint Test | GO to Pinpoint Test C |
| The DTE-low fuel indication, drive mode, digital speedometer, clock or outside air temperature display is inoperative | Refer to the Pinpoint Test | GO to Pinpoint Test D |
| An infotainment menu (audio, navigation or phone) does not display or cannot be navigated | IPC infotainment menu concern | REFER to: Information and Entertainment System . |
| The LH- RH turn/hazard signal display is inoperative | Refer to the Pinpoint Test | GO to Pinpoint Test E |
| The lane keeping system display (part of the active driver assist system) is inoperative | Refer to the Pinpoint Test | GO to Pinpoint Test F |
| The tachometer (engine rpm) indication is inoperative | Refer to the Pinpoint Test | GO to Pinpoint Test G |
| The transmission gear display indication is inoperative | Refer to the Pinpoint Test | GO to Pinpoint Test H |
| The unit or language selection cannot be changed | Refer to the Pinpoint Test | VERIFY the units or language selections can be changed in the IPC. If the units or language selections cannot be changed in the IPC, DIAGNOSE the message center menu does not display or cannot be navigated. Refer to: Instrumentation, Message Center and Warning Chimes . If the units or language selections can be changed in the IPC, INSTALL a new HUD module. Refer to: Head Up Display (HUD) Module . |