Removal And Installation: Condenser: Removal

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: During the removal of components, cap, tape or otherwise appropriately protect all openings to prevent the ingress of dirt or other contamination. Remove protective materials prior to installation.

NOTE: Removal steps in this procedure may contain installation details.

NOTE: Expedition shown, Navigator similar.

Recover the refrigerant. Refer to the appropriate Recovery procedure in GENERAL PROCEDURES .
With the vehicle in N, position it on a hoist. Refer to: Jacking and Lifting .
1. Remove the retainer.
2. Remove the push pin retainers and the air intake.
Courtesy of FORD MOTOR COMPANY
Remove the push pin retainers and the air deflector.

Courtesy of FORD MOTOR COMPANY
Remove the retainers and tilt the cooling module.
Torque: 133 lb.in (15 Nm)

Courtesy of FORD MOTOR COMPANY
Position the lower air deflector aside.

Courtesy of FORD MOTOR COMPANY
1. Remove the nut and disconnect the thermostatic expansion valve manifold and tube assembly.
  Torque: 89 lb.in (10 Nm)
2. Remove the retainer.
  Torque: 89 lb.in (10 Nm)
- Make sure to cover any open ports to prevent debris from entering the system.
Courtesy of FORD MOTOR COMPANY
1. Remove the nut and disconnect the A/C fitting.
  Torque: 159 lb.in (18 Nm)
2. Disconnect the electrical connector from the A/C pressure transducer.
- Make sure to cover any open ports to prevent debris from entering the system.
Courtesy of FORD MOTOR COMPANY
1. Remove the nut and the A/C compressor outlet line.
  Torque: 159 lb.in (18 Nm)
2. Remove the retainer.
  Torque: 89 lb.in (10 Nm)
- Make sure to cover any open ports to prevent debris from entering the system.
Courtesy of FORD MOTOR COMPANY
Release the tab and remove the condenser.

Courtesy of FORD MOTOR COMPANY