Fuel Lines: Removal
WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Removal steps in this procedure may contain installation steps.
- With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting .
- Disconnect the battery ground cable. Refer to: Battery Disconnect and Connect .
- Release the fuel system pressure. Refer to: Fuel System Pressure Release (310-00 Fuel System - General Information - 3.5L EcoBoost (272kW/370PS)).
- Remove the engine appearance cover retainers, release the engine appearance cover from the rear retainers and then remove the engine appearance cover.
Torque: 97 lb.in (11 Nm)
-
- If equipped, remove the bolts.
- Release the retainer and remove the transmission housing cover.
- Release the quick connect coupling.
- Release the retainer clip on the rear of the transmission and position aside the fuel supply line.
-
- Disconnect the front fuel supply line-to-fuel tank fuel supply line quick connect coupling. Refer to: Quick Release Coupling .
- Release the retainer clips.
- Remove the fuel feed line from the bottom of the vehicle.
- If equipped
- Disconnect the front fuel supply line-to-fuel tank fuel supply line quick connect coupling. Refer to: Quick Release Coupling .
- Release the retainer clips.
- Remove the fuel feed line from the bottom of the vehicle.