Transmission Support Insulator: Installation

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.

Rear Wheel Drive (RWD) vehicles

Install the transmission support insulator.

Courtesy of FORD MOTOR COMPANY
- Loosely install the new transmission support insulator bolts.
- Tighten the transmission support insulator bolts in the sequence shown.
  Torque: 66 lb.ft (90 Nm)
Fig 1: Transmission Support Insulator Bolts Tightening Sequence
Courtesy of FORD MOTOR COMPANY
Install the LH isolator cap and the bolt.
Torque: 41 lb.ft (55 Nm)

Courtesy of FORD MOTOR COMPANY

Four-Wheel Drive (4WD) vehicles
Install the transmission support insulator.

Courtesy of FORD MOTOR COMPANY
Loosely install the new transmission support insulator bolts.

Courtesy of FORD MOTOR COMPANY
Tighten the transmission support insulator bolts in the sequence shown.
Torque: 76 lb.ft (103 Nm)

Fig 2: Transmission Support Insulator Bolts Tightening Sequence
Courtesy of FORD MOTOR COMPANY
Install the LH isolator cap and the bolt.
Torque: 41 lb.ft (55 Nm)

Courtesy of FORD MOTOR COMPANY

All vehicles
Install the transmission support crossmember. Refer to: Transmission Support Crossmember .