LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 1082 (Automatic Transmission - 10R80 (2 Of 2)) >> Removal And Installation >> Output Shaft Seal >> Installation

Output Shaft Seal: Installation

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using the special tool, install the new output shaft seal. Use Special Service Tool: 307-660 Installer, Front Pump Seal.
    GFD273491Courtesy of FORD MOTOR COMPANY

    Rear Wheel Drive (RWD) vehicles 

  2. Using the special tool, install the new output shaft nut. Use Special Service Tool: 307-458 Socket, Output Shaft Locknut.

    Torque: 148 lb.ft (200 Nm)

    GFD273492Courtesy of FORD MOTOR COMPANY
  3. Align the index marks on the output shaft and the output shaft flange made during removal.
    GFD273493Courtesy of FORD MOTOR COMPANY
  4. Install the new output shaft flange bolt.

    Torque: 81 lb.ft (110 Nm)

    GFD273494Courtesy of FORD MOTOR COMPANY
  5. Install the rear driveshaft assembly. Refer to: DRIVESHAFT .

    Four-Wheel Drive (4WD) vehicles 

  6. Install the transfer case assembly. Refer to: Transfer Case .

    All vehicles 

  7. Check the transmission fluid level. Refer to: Transmission Fluid Level Check .
scientia non olet · About LEMON Manuals