Turbocharger Internal Oil Leak Test
WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
It is normal for a small amount of combustion gas to pass into the crankcase. This gas is scavenged into the air intake system through the positive crankcase ventilation system, which incorporates an crankcase vent oil separator. Some engine oil, in the form of a vapor is carried into the air intake system with the blow-by gases (this engine oil also contributes to valve seat durability). This means that oil will collect inside the air intake components and the turbocharger. This is not an indication that the turbocharger oil seal has failed. The turbocharger oil seal will generally not fail unless the bearings fail first, which will cause the turbocharger to become noisy or seize. Do not install a new turbocharger due to oil inside the turbocharger or the air intake components. If a leak is detected in the oil supply or return tubes or connections, locate and rectify the source. Do not install a new turbocharger due to an oil leak.
Check the turbocharger compressor inlet for evidence of oil. If excessive oil is present, this indicates that the failure could be in the engine or turbocharger. REFER to:SPECIFICATIONS
. Or see the following turbocharger check. If excessive oil is found in the turbocharger compressor outlet, check the charge air cooler for oil contamination. If contamination is present, flush the charge air cooler. REFER to: Charge Air Cooler (CAC) Cleaning
.
Check the turbocharger turbine outlet for evidence of oil. If excess liquid oil is present in the outlet, remove the turbocharger from the engine and examine the oil supply and return passages in the turbocharger, engine block and the turbocharger oil drain tube for restriction. If no restriction is found, install a new turbocharger. REFER to: Turbocharger LH .
REFER to: Turbocharger RH .