LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 107 (Engine Controls (Diagnostics) (H4DO)) >> Drive Cycle >> Procedure >> Drive Cycle F >> Diagnostic procedure

Diagnostic procedure

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Make sure that the engine coolant temperature is less than 30°C (86°F).
  2. Drive according to the drive pattern described below.
    Fig 1: Drive Pattern Chart
    G07670222Courtesy of SUBARU OF AMERICA, INC.
    NOTE:
    • There is no given transition time between idling and cruising.
    • Driving at constant speed only on a downhill causes smaller engine load and may result in failure to obtain a right diagnostic result.
    • When the engine stops while performing drive cycle F, perform it again from the state of procedure 1).
scientia non olet · About LEMON Manuals