LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 107 (Engine Controls (Diagnostics) (H4DO)) >> Diagnostic Procedure with Diagnostic Trouble Code (DTC) >> DTC P0198 Engine Oil Temperature Sensor High >> Wiring Diagram

DTC P0198 Engine Oil Temperature Sensor High: Wiring Diagram

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Engine Oil Temperature Sensor High - Wiring Diagram
G07670269Courtesy of SUBARU OF AMERICA, INC.
DIAGNOSIS PROCEDURE

Step Check Yes No
1 CHECK CURRENT DATA. 
  1. Start the engine.
  2. Read the data of engine oil temperature sensor signal using Subaru Select Monitor or general scan tool.
    NOTE:
    • Subaru Select Monitor

      For detailed operation procedures, refer to "READ CURRENT DATA FOR ENGINE". < refer to SUBARU SELECT MONITOR . >

    • General scan tool

      For detailed operation procedures, refer to the general scan tool operation manual.

 Is the engine oil temperature -40°C (-40°F)? Go to step 2.  Even if DTC is detected, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.
NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.
2 CHECK FOR POOR CONTACT. 
Check for poor contact between the ECM and engine oil temperature sensor connectors.		 Is there poor contact of the ECM or engine oil temperature sensor connectors? Repair the poor contact of ECM or engine oil temperature sensor connector. Go to step 3  .
3 CHECK HARNESS BETWEEN ECM AND ENGINE OIL TEMPERATURE SENSOR CONNECTOR. 
  1. Turn the ignition switch to OFF.
  2. Disconnect the connectors from the ECM and engine oil temperature sensor.
  3. Measure the resistance of the harness between the ECM and engine oil temperature sensor connector.

    Connector & terminal 

    (B137) No. 9 - (E75) No. 2: 

    (B134) No. 29 - (E75) No. 1: 

 Is the resistance less than 1 Ω? Go to step 4.  Repair the harness and connector.
NOTE: In this case, repair the following item:
  • Open circuit in harness between ECM and engine oil temperature sensor connector
  • Poor contact of coupling connector
4 CHECK HARNESS BETWEEN ECM AND ENGINE OIL TEMPERATURE SENSOR CONNECTOR. 
  1. Connect all connectors.
  2. Turn the ignition switch to ON.
  3. Measure the voltage between ECM and chassis ground.

    Connector & terminal 

    (B137) No. 9 (+) - Chassis ground (-): 

 Is the voltage 5 V or more? Repair the short circuit to power in harness between ECM and engine oil temperature sensor connector. Replace the engine oil temperature sensor. < refer to ENGINE OIL TEMPERATURE SENSOR . >
scientia non olet · About LEMON Manuals