Pinpoint Test C : B1368:29: Notes

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.

B1368:29

Refer to Wiring Diagram Adjustable Pedal for schematic and connector information.

Normal Operation and Fault Conditions

The adjustable pedal motor contains a Hall-effect sensor allowing the BCMB to monitor the adjustable pedal position. The BCMB stores the sensor information and uses this information when a memory position is recalled using the memory SET switch, a RKE transmitter or a passive ignition key.

When 1 or more of the following Diagnostic Trouble Codes (DTCs) is set, the adjustable pedals enter a "jog mode". When the pedals are in jog mode, the memory system recall does not function from the memory SET switch, RKE transmitter or passive ignition key. When in jog mode and the adjustable pedal control switch is pressed, the motor moves the pedals for 2 seconds in the direction selected regardless of the length of time the switch is actually pressed.

DTC Fault Trigger Conditions

DTC	Description	Fault Trigger Conditions
B1368:29	Adjustable Pedal Position Feedback Sensor: Signal Invalid	This DTC sets in continuous memory or on demand if the Hall-effect feedback voltage is less than 3.5 volts or the Hall-effect monitor voltage is greater than or equal to 6.85 volts.

Possible Causes

Foreign material
Wiring, terminals or connectors
Adjustable pedal motor