Rear Halfshaft: Installation

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The halfshaft seal has to be replaced whenever the halfshaft is removed.

Replace the halfshaft seal. Refer to: REAR HALFSHAFT SEAL .
Install a new inner halfshaft circlip.

Courtesy of FORD MOTOR COMPANY
NOTE: After insertion, pull the halfshaft inner end to make sure the circlip is locked.

NOTE: When seated correctly, the halfshaft retainer circlip can be felt as it snaps into the differential side gear groove.

Install the halfshaft until the halfshaft circlip is fully seated.

Courtesy of FORD MOTOR COMPANY
Install the wheel knuckle. Refer to: WHEEL KNUCKLE .
Check and top off the rear differential fluid. Refer to: Differential Fluid Level Check .