Rear Suspension Height Sensor: Removal

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Removal steps in this procedure may contain installation details.

Position vehicle on a hoist. Refer to: Jacking and Lifting .
NOTE: Note the position of the components before removal.

NOTE: LH height sensor assembly shown, RH similar.
1. Disconnect the height sensor electrical connector.
2. Remove the bolt and detach the height sensor arm from the lower control arm.
  Torque: 177 lb.in (20 Nm)
3. Remove the height sensor bracket bolt and remove the height sensor.
  Torque: 97 lb.in (11 Nm)

Courtesy of FORD MOTOR COMPANY