Toe Link: Installation

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Tighten the suspension bushing fasteners with the suspension loaded or with the weight of the vehicle resting on the wheels and tires, otherwise incorrect clamp load and bushing damage may occur.

Using the index marks made in removal Step 2, transfer the marks onto the new cam bolt and cam washer.
NOTE: Only tighten the nut and bolts finger tight at this stage.
1. NOTE: Align reference marks made during removal.
  
  Install the toe link and install the new outboard toe link bolt.
2. Install the new toe link inboard cam bolt and nut.
Courtesy of FORD MOTOR COMPANY
Install the wheel and tire. Refer to: Wheel and Tire .
1. NOTE: Align reference marks made during removal.
  
  Tighten the toe link-to-wheel knuckle bolt.
  
  Torque: 166 lb.ft (225 Nm)
2. Tighten the toe link-to-frame cam bolt and nut.
  Torque: 203 lb.ft (275 Nm)
Courtesy of FORD MOTOR COMPANY
Check and if necessary adjust rear toe. Refer to: Rear Toe Adjustment .