Rear Stabilizer Bar: Removal

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Tighten fasteners as specified.

Remove the wheel and tire. Refer to: Wheel and Tire .
NOTE: Do not use power tools to remove or install the stabilizer bar link nuts. Damage to the stabilizer bar link ball joints and boots may occur.

NOTE: Use the hex-holding feature to prevent the ball stud from turning while removing the stabilizer bar link nut.

On both sides. Remove and discard the rear stabilizer bar link nut and keep aside stabilizer bar link.

Courtesy of FORD MOTOR COMPANY
On both sides.
1. Remove and discard the rear stabilizer bar bracket nuts.
2. Remove the rear stabilizer bar bushings.
3. Remove and discard the rear stabilizer bar stud plates.
4. Remove the rear stabilizer bar.

Courtesy of FORD MOTOR COMPANY