Front Wheel Bearing and Wheel Hub: Installation

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Tighten the bolts in a cross pattern.

Install the front wheel bearing and wheel hub and install the 4 front wheel bearing and wheel hub bolts.

Torque: 129 lb.ft (175 Nm)

Courtesy of FORD MOTOR COMPANY
1. Position the wheel speed sensor wire and clip the wheel speed sensor wire retainers.
2. Install the wheel speed sensor wire bracket bolt on the wheel knuckle.
  Torque: 106 lb.in (12 Nm)
3. Install the wheel speed sensor wire bracket bolt.
  Torque: 106 lb.in (12 Nm)
Courtesy of FORD MOTOR COMPANY
Install the brake disc shield. Refer to: Brake Disc Shield .
NOTE: The wheel speed sensor electrical connector is located in the engine compartment secured to the fender apron.

Connect the wheel speed sensor electrical connector.

Courtesy of FORD MOTOR COMPANY