LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 1038 (Sunroof System (Service Information)) >> 60 Sunroof >> Sliding Sunroof >> Power Sunroof Control Module -J245-, Removing And Installing

Power Sunroof Control Module -J245-, Removing And Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

After The Removal And Installation Of The Sunroof Motor, The Neutral Position Of The Slotted Guide Rail Must Be Checked And Adjusted If Necessary. Refer to AVANT NEUTRAL POSITION .

-- Remove the interior lighting cover. Refer to the appropriate information; LEFT/RIGHT FRONT READING LAMP BUTTON -E633- / -E634-, REMOVING AND INSTALLING and/or FRONT INTERIOR LAMP -W1- /FRONT PASSENGER READING LAMP -W13- /DRIVER READING LAMP -W19-, REPLACING

-- Disconnect the connectors.

-- Remove the three bolts and remove the motor through the opening in the headliner. Refer to -item  1- Bolt.

-- After installing, perform an adaptation.

scientia non olet · About LEMON Manuals