LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 1038 (Sunroof System (Service Information)) >> 60 Sunroof >> Sliding Sunroof >> Glass Panel, Removing And Installing >> Sunroof Panel >>2<< For Panorama Sunroof, Removing And Installing,

Sunroof Panel >>2<< For Panorama Sunroof, Removing And Installing,

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

If The Screws For The Panel Mounting Were Completely Removed, Then They Must Be Replaced.

Fig 1: Exploded View Of Sunroof Panel >>2<< For Panorama Sunroof
GWWA60-10440Courtesy of AUDI OF AMERICA, LLC
  1. Bolt
    • 3 Nm
  2. Sunroof panel >>2<<
    • Open the sun shade completely and remove the side noise seal. Refer to -item  2- Seal.
    • Remove both front and rear screws and remove the sunroof panel.

      -- Install in reverse order of removal.

  3. Panel Seal

    -- Sunroof panel >>2<< removed.

    -- Pull the seal off the sunroof panel starting on the left and right sides.

    -- Pull the front seal upward off the sunroof panel.

    • Align the sunroof panel at the front and center and push it into the guides. Refer to Sunroof Seals, Removing and Installing, Avant SUNROOF SEALS, REMOVING AND INSTALLING, AVANT 

      -- Insert the ends of the seal onto the molding pins.

scientia non olet · About LEMON Manuals