LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 1037 (Climate Control (Service Information - Refrigerant 134A)) >> 87 Air Conditioning >> A/C Service Station, Connecting >> Service Station, Connecting With No Connection On Low- And High Pressure Side Of Refrigerant Circuit >> A/C Service Station, Connecting For Measuring And Testing

A/C Service Station, Connecting For Measuring And Testing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- On vehicles with a high-voltage system, switch off (deactivate) the "auxiliary climate control" function. Refer to the Owner's Manual and Infotainment/MMI Operating Manual.

-- Switch off the ignition.

-- Connect the A/C service station to the power supply.

-- Assemble adapter set and screw to connection on low-pressure side.

-- Connect the quick-release coupling adapter to the charging hoses of service station (handwheels not screwed in/hand shut-off valve not open).

-- Switch on the service station and evacuate the charging hoses (only necessary if there is air in charging hoses).

-- Switch off the service station.

-- Remove the cap from the service connection/connection with valve (or remove low-pressure switch and bridge respective electrical connections).

-- Connect the service station via the service connections with the quick-release coupling adapters to the vehicle refrigerant circuit.

-- Install the handwheel on the quick-release coupling adapters only until valve is definitely open at refrigerant circuit connection (observe pressure gauge, do not strain valve).

-- Perform the planned tests and measurements.

scientia non olet · About LEMON Manuals