Undamaged Side Window, Removing, Sedan

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Procedure

CAUTION:

In the window glass cutting area, protect the side panel and roof against paint damage with adhesive tape.

-- Remove the inner door seal in the >>C-pillar<< and side window area.

-- The >>C-pillar<< trim is removed.

-- Remove the roof trim molding.

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

The roof trim molding must not be bent.

-- Route the cutting wire around the side window as shown.

-- Secure ends X and Y in two pull grips from :VAG1351 .

-- Pull the cutting wire forward in the direction of arrow -A- using light sawing motions and cut through lower adhesive bead at the side panel and at the roof frame.

-- In this way, first the locating pin on the rear of the window and then the adhesive bead are cut through.

-- Then pull the cutting cord in the direction of the arrow -B- downward through the adhesive bead.

-- Remove the window glass from the window opening.