LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 1028 (Cylinder Head, VALVETRAIN- CREC, Cred, CREH) >> Cylinder Head, VALVETRAIN >> VALVETRAIN >> Valve Stem Seals, Removing And Installing >> Valve Stem Seals, Removing And Installing, Cylinder Head Installed >> Assembling

Valve Stem Seals, Removing And Installing, Cylinder Head Installed: Assembling

WARNING: This page is about a different car, the 2018 Audi A6 Quattro, 2017 Audi A6 Quattro, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Make sure all the roller rocker levers lie on the ends of the valve stems correctly and are clipped onto the respective hydraulic adjusting elements.

-- Install the spark plugs.

-- Install the camshafts. Refer to CAMSHAFT, REMOVING AND INSTALLING .

CAUTION:

Risk of damaging valves and piston heads after working on valve train.

  • The motor must not be started for about 30 minutes after installing camshafts because the hydraulic equalization elements must seat themselves.
  • To ensure valves do not strike pistons when starting, carefully rotate engine at least two full revolutions.
scientia non olet · About LEMON Manuals