Oil Pan Lower Section, Removing And Installing: Installing

WARNING: This page is about a different car, the 2018 Audi A6 Quattro, 2017 Audi A6 Quattro, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Replace the gaskets after removing.

Replace the lower section of the oil pan if the coating on it is damaged or if it is bent.

CAUTION:

Risk of contaminating lubricating system and bearing.

Cover open parts of engine.

Courtesy of AUDI OF AMERICA, LLC

WARNING:

Danger of eye injury.

Wear protective eyewear.

-- Remove any sealant residue on the oil pan lower -1- and upper sections using a rotating plastic brush.

-- Clean any oil or grease off the sealing surfaces.

NOTE:

Pay attention to the expiration date of the sealant.

-- Cut the tube nozzle at the front marking (tube nozzle diameter: approximately 1 mm).

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

The lubrication system could be plugged with excess sealant.

Do not apply sealant bead thicker than indicated.

-- Apply a sealant bead -arrow- to the clean sealing surface on the lower part of the oil pan as shown in illustration.

Courtesy of AUDI OF AMERICA, LLC

Sealant bead thickness is approximately 1.5 mm.

NOTE:

Install the lower section of the oil pan within five minutes of applying the sealant.

-- Mount the oil pan lower section -2- and tighten the bolt. Refer to Figure and then connect the connector -1-.

Courtesy of AUDI OF AMERICA, LLC

Installation is performed in reverse order of removal, while noting the following:

-- Fill the engine oil and check the oil level. Refer to appropriate service information.