Calibration Board Orientation

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Position the calibration platform behind the vehicle at a distance of 1.47 m to 1.90 m to the rear wheels, see -dimension A- in the overview illustration. Refer to Calibration Tool .

-- Bring the :VAS6350A into a horizontal position.

-- To do so, twist plastic feet under calibration device so that air bubble in level is located exactly in the center of the indicator -arrow-.

Courtesy of AUDI OF AMERICA, LLC

WARNING:

Make sure light does not reflect off the calibration board.

Reflections impair the Rearview Camera -R189- and may make it impossible to perform the calibration.

-- Switch on the :VAS6350/3 -1- on the calibration board and adjust the entire :VAS6350A so that the laser beam hits the center of vehicle rear above the Audi rings.

Courtesy of AUDI OF AMERICA, LLC

-- Make sure the Audi rings are centered on the rear. Correct the laser beam accordingly.

Continue calibrating the Rearview Camera -R189-. Refer to Rearview Camera -R189-, CALIBRATING .