Rear Peripheral Camera -R246-, REMOVING AND INSTALLING, AVANT: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
The Rear Peripheral Camera -R246- has a trailing cable. The vehicle wiring harness couplings are located in the rear lid.
-- Remove the lower rear lid trim panel. Refer to LUGGAGE COMPARTMENT TRIM PANELS .
-- Unlock and disconnect the connectors -1, 2 and 4- inside the rear lid.
The Rear Peripheral Camera -R246- is permanently attached to the handle button -3-.
-- Remove the nuts -arrows-.
NOTE:
Depending on the market, it may be necessary to remove the license plate or the license plate bracket.
-- Pull the handle button -3- with the Rear Peripheral Camera -R246- out of the retainer in the rear lid.