MULTIFUNCTION Buttons, Removing And Installing, 3-Spoke Steering Wheel: Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Install in reverse order of removal. Note the following:
-- Place the decorative trim with mounted multifunction buttons onto the steering wheel.
-- Route the connection cable for the tiptronic switch -2- as shown.
-- Route the rest of the connection cable, including the connector, into the guides inside the steering wheel.
-- Push the decorative trim -2- with multifunction buttons onto the steering wheel -1- until it engages securely.
-- Finally, check the steering wheel again to make sure the wiring is correct.