Oil Pump, Removing And Installing: Installing
WARNING: This page is about a different car, the 2018 Audi S6, 2017 Audi S6, and 2016 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.
Install In Reverse Order Of Removal. Note The Following:
NOTE:
Replace The Seals And The O-Ring.
Replace Any Bolts That Were Tightened With An Additional Turn.
-- Install the seal -1- for the oil pump.
- The seal is installed on the connection -arrow A- next to the spur gears.
- The second connection -arrow B- does not contain a seal.
-- Install the oil pan lower section. Refer to OIL PAN LOWER SECTION, REMOVING AND INSTALLING .
-- Install the coolant pump. Refer to COOLANT PUMP, REMOVING AND INSTALLING .
-- Install the spur gear unit. Refer to SPUR GEAR DRIVE, REMOVING AND INSTALLING .
-- Fill With Engine Oil And Check The Oil Level. Refer to the appropriate service information.
NOTE:
Do Not Reuse Used Coolant.
-- Fill with coolant. Refer to FILLING .