Oil Pan Lower Section, Removing And Installing: Removing

WARNING: This page is about a different car, the 2018 Audi S6, 2017 Audi S6, and 2016 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.

Engine Oil Is Drained. Refer to the appropriate service information.

-- Remove bolt -1-, loosen but do not remove bolt -3-.

Courtesy of AUDI OF AMERICA, LLC

-- Push the mount -2- with the wire toward the rear.

-- Remove the nuts -arrows- and lower the stabilizer bar.

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -1- on the Oil Level Thermal Sensor -G266-.

Courtesy of AUDI OF AMERICA, LLC

-- Free up the electric wires.

CAUTION:

There Is A Risk Of Contamination.

There is still a residual amount of oil in lower section of oil pan.

-- Loosen and remove the bolts -arrows- in a diagonal sequence.

-- Loosen and remove the oil pan lower section carefully from the adhesive.