Overview - Mechanical Control Valve, Check Valve, Cover In Inner V: Notes

WARNING: This page is about a different car, the 2018 Audi S6, 2017 Audi S6, and 2016 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Mechanical Control Valve And Check Valve

Courtesy of AUDI OF AMERICA, LLC

O-Ring
- Always replace
Check Valve
- Removing and Installing. Refer to CHECK VALVE, REMOVING AND INSTALLING .
Oil Screen
- Always replace
- Install the cover -11-
- Removing and Installing. Refer to COVER IN THE INNER-V, REMOVING AND INSTALLING .
Seal
- Always replace
Bolt
- Tightening specification and sequence. Refer to Figure.
- Always replace
O-Ring
- Always replace
Bolt
- Tightening specification, refer to -item 8-.
Piston Cooling Nozzle Control Valve -N522-
- Removing and Installing. Refer to Piston Cooling Nozzle Control Valve -N522-, REMOVING AND INSTALLING .
Oil Pressure Switch, Level 3 -F447-
- Switching pressures 0.3 to 0.6 bar.
- Green insulation
- Check in Guided Fault Finding using the Vehicle Diagnostic Tester.
- Removing and Installing. Refer to Oil Pressure Switch, Level 3 -F447-, REMOVING AND INSTALLING .
- Tightening specification, refer to -item 9-.
Seal
- Always replace
Cover
- In the inner V
- Removing and Installing. Refer to COVER IN THE INNER-V, REMOVING AND INSTALLING .
Plug
- 30 Nm
Mechanical Switch Valve
- Removing and Installing. Refer to MECHANICAL SWITCH VALVE, REMOVING AND INSTALLING .
O-rings
- Always replace