LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 1024 (Engine Lubrication System (Service Information - CEUC, CRDB, CTGE, CWUB, CWUC)) >> 17 Lubrication >> Oil Circuit >> Overview - Mechanical Control Valve, Check Valve, Cover In Inner V >> Cover Bolts Tightening Sequence And Specifications

Cover Bolts Tightening Sequence And Specifications

WARNING: This page is about a different car, the 2018 Audi S6, 2017 Audi S6, and 2016 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Cover Bolts Tightening Sequence
GWWA17-11072Courtesy of AUDI OF AMERICA, LLC
NOTE:

Replace The Bolts That Were Tightened With An Additional Turn.

-- Tighten The Bolts In Stages As Follows: 

Step Bolts Tightening Specification/Additional Turn
1.  -1 to 11- Install by hand all the way
2.  -1 to 11- 5 Nm diagonally
3.  -1 to 11- In a diagonal sequence, turn an additional 90°
scientia non olet · About LEMON Manuals