Cylinder Bank 1 (Right):

WARNING: This page is about a different car, the 2018 Audi S6, 2017 Audi S6, and 2016 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Do not change the shape of the fuel line.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the right coolant pipe. Refer to RIGHT COOLANT PIPE, REMOVING AND INSTALLING .

-- Remove the bolts -arrows- and press the fuel line -1- forward.

-- Disconnect the connectors -1 and 2- and free up the wiring harness.

Courtesy of AUDI OF AMERICA, LLC

-- Attach both of the camshaft adjusters without camshaft timing chains to the cylinder head and then loosely screw on the bolts -1 and 2-.

Courtesy of AUDI OF AMERICA, LLC

-- Position the :T40269 onto the camshaft adjuster for the right exhaust camshaft and counterhold with a wrench -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the bolt -1- by hand.

NOTE:

To loosen the bolt for the :T40264/1 , the exhaust camshaft must be secured from turning.

-- Hold the exhaust camshaft in position with the wrench.

-- Remove the left bolt -left arrow- from the :T40264/1 .

Courtesy of AUDI OF AMERICA, LLC

-- Release the wrench.

When doing this, the exhaust camshaft turns to the right one turn.

-- Position the :T40269 onto the camshaft adjuster for the left intake camshaft and counterhold with a wrench -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the bolt -1- by hand.

NOTE:

To loosen the bolt for the :T40264/1 , the intake camshaft must be secured from turning.

-- Hold the intake camshaft in position with the wrench.

-- Remove the right bolt -right arrow- from the :T40264/1 .

Courtesy of AUDI OF AMERICA, LLC

-- Release the wrench.

When doing this, the intake camshaft turns to the right one turn.

-- Remove the :T40264/1 .

-- Remove the bolts -1 and 2- by counterholding with the wrench and the :T40269 . Remove the camshaft adjuster.

Courtesy of AUDI OF AMERICA, LLC