LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 1018 (Suspension System (Self-Leveling - Service Information)) >> Self-Leveling Suspension >> Dynamic Ride Control (DRC) >> Electronic Damping Control Module -J250-, REMOVING AND INSTALLING >> Notes

Electronic Damping Control Module -J250-, REMOVING AND INSTALLING: Notes

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

The control module is not designed for coding and adaptation when replaced, so the "Replace" function in "Guided Fault Finding  " cannot be performed with the Vehicle Diagnostic Tester.

The new Electronic Damping Control Module -J250- can be used right away.

NOTE:

The Electronic Damping Control Module -J250- is installed behind the right side trim panel inside the luggage compartment.